
The finish is the product.
Acrylic render systems over lightweight boards, cement render over masonry, textures from fine sand to heavy trowel, and the exterior paint schedule that protects it all. One crew, one colour system, one warranty.
Acrylic render systems
Polymer-modified basecoat with embedded alkali-resistant mesh, acrylic texture and membrane topcoat. Build-up set by the substrate's CodeMark: 5 mm standard, 10 mm or 17.5 mm for bushfire ratings.
See the substrates →Cement render
Sand and cement render with bonding agent, floated flat, then acrylic texture and topcoat. For ground floors, garages, retaining and the brick house that wants a new face.
Ask about masonry render →AAC render systems
Polymer render over PowerPanel or block with the panel joints meshed and the slab junction detailed, finished with texture and membrane. Non-combustible renders available for Type A and B work.
See the Hebel system →From flat to full trowel.
Sample boards made up in the actual colour before the crew starts.
| Finish | Look | Where |
|---|---|---|
| Fine sand | Flat, even, almost painted | Modern facades, parapets, boxed eaves |
| Medium sand | Soft, consistent grain | The volume builder standard |
| Coarse sand | Heavier grain that hides substrate | Masonry render, large elevations |
| Trowel-on and Tuscan | Hand-worked movement | Mediterranean and heritage styles |
| Bag and float | Rough, loose, brick showing through | Courtyard walls, fences, character homes |
| Polished and Venetian | Smooth, burnished, stone-like | Entries, feature walls, interiors |
The topcoat is part of the system.
On a rendered lightweight wall the membrane topcoat is not decoration. It is the layer that keeps water out of the basecoat, holds the colour and carries the warranty. We apply it as the manufacturer specifies: sealer plus two coats, three on commercial work, and we keep the colour's light reflectance value at 40 or above on EPS systems so the facade never overheats.
- Exterior paint schedules for render, cladding, eaves, fascia, trims and garage doors in one visit
- Dulux AcraShield, Unitex Uni-PTC, StoColor and Rockcote membranes to match the substrate warranty
- Colour consultation against the builder's facade schedule or the owner's palette, with LRV checked before the order goes in
- Repaints of existing rendered homes: wash, crack repair, joint reseal, recoat
Minimum cure between coats on Unitex systems, checked at 12 percent moisture before the next goes on
Maximum spacing of control joints in both directions on EPS, and at every floor level
The lightest colour value allowed on an EPS facade, a warranty condition on every system we install
Maximum pressure for the annual wash that keeps the manufacturer warranty alive
Mesh overlap at every lap, and the return around every corner and opening
Of membrane for a ten-year coating warranty; three for fifteen



